Pulsar Axion 2 - Page 29

select the desired calibration mode: Manual (M), Semi-Automatic
(SA) or Automatic (A).
6.
Calibrate the image by briefly pressing the ON/OFF (6)button.If the SA
or A calibration mode has been selected the microbolometer is closed
with an internal shutter automatically. However, if the M calibration
mode has been selected you must close the lens cover before
calibrating manually.
7.
Select the required amplification level (“Normal” , “High”
, “Ultra” ) by briefly pressing the UP (5) button.
8.
Enter the main menu with a long press of the MENU (4) button and
select the desired colour mode (for more details see the Colour Modes
section).
9.
Activate the quick menu by briefly pressing the MENU (4) button to
adjust the brightness, contrast and smooth digital zoom (for more
details see the Quick Menusection).
10.
After use, turn the device off by a long press of the ON/OFF (6)
Warning!Never point the lens at intensive energy sources such as laser
radiation emitting devices or the sun. It can damage electronic components
in the device. The warranty does not cover damage arising from failure to
comply with operating instructions.