ENGLISH
sold separately.
• Connect the plug of
the USB Type-C cable
(16) to the USB Type-C
connector of the Power
Adapter (15).
• Plug the Power Adapter
(15) into a 100-240 V
socket (17).
• Connect the other end
of the USB Type-C cable
(16) to the USB Type-C
connector (14) of the
charger.
• LED indication (13) will
display battery charge
level (see Table).
• Two batteries can be
charged at the same
time: the second slot is
designed for it.
LED indication (13) in the battery charging mode:
Battery Level
Battery level is from 0% to 25%
Battery level is from 26% to 50%
Battery level is from 51% to 80%
Battery level is from 81% to 99%
The battery is fully charged. It can be disconnected from the charger.
Defective battery. It is forbidden to use the battery.
LED indication (13) in the standby mode*:
Battery Level
Battery level is from 0% to 25%
Battery level is from 26% to 50%
Battery level is from 51% to 80%
Battery level is from 81% to 99%
The battery is fully charged. It can be disconnected from the charger.
Defective battery. It is forbidden to use the battery.
* Standby mode – operating mode when the batteries in the charger, but
the power adapter is not connected. In this mode, the indication is on for 10
seconds.
Attention! When using a power adapter that does not support USB Power
Delivery fast charging technology, the icker frequency of LED indicators
decreases by 3 times and charge time increases.
Attention! The charger heats up during fast charging. Excess heat is removed
through the radiator and does not affect the device operation.
3
To Next Page
Loading...
