9
8
MENU
9
Rangefinder*
Color modes*
Operating mode
Image calibration
Video output
Clock setup
Defective pixel repair
Brightness setting of menu icons
Selection of units of measurement*
* Available only in XD series.
The menu includes options as follows:
Point the unit at a warm object located at a certain distance,
100 meters, for example.
Adjust the focus by turning the ring for lens internal focusing (6).
After this adjustment no further dioptre adjustment should be required,
regardless of distance or other factors. Adjust image quality only with
the ring (6) for lens internal focusing.
STATUS BAR
Status bar in the bottom part of the display shows information
as follows:
Three operating modes – “City”, “Forest”, “Identification”
Three calibration modes - manual, semiautomatic and automatic
Digital zoom 2x (LD series) (2х / x4 – XD series only)
Running time
Battery status or external power supply connected
Rangefinder (available only in XD series)
Thermal imagers Quantum XD are equipped with a stadiametric
rangefinder which allows the user to estimate approximate distance to an
object with known size.
Press and hold down the controller (5) for two seconds to enter the
menu.
Rotate the controller to select menu option . Press the controller.
Press the controller to select one of the
reference objects, whose sizes are roughly
equal to the size of the actual object under
measurement:
Reference object “Hare” – height 0.3m
Reference object “Wild hog” – height 0.7m
Reference object “Deer” – height 1.7m
Note: to switch between units of measurements – metres or yards – please
refer to the menu option “Selection of units of measurement”.
To activate the rangefinder, press the controller until you see on the
display: two horizontal lines for measurement, readings of measured
distance and icon of selected reference object (see Pic.).
Locate the lower fixed line under the observed object and, while
rotating the controller, move the upper line relative to the lower fixed line
until the observed object fully fits between the two lines. The distance to
the observed object is automatically recalculated as you move the
upper line.
If the measurement does not take place within 2-3 seconds,
information disappears from the display. When rotating the controller
again, distance measuring mode re-activates.
Below is a table of distance measuring range:
Thermal imager model
Type of reference object
Max. range of measuring
distances, m / yard
Quantum XD19S
Wild hog
170/
185
Quantum XD38S
Wild hog
335/
370
Quantum XD50S
Wild hog
445/
485
Hare
72/
79
Deer
410/
450
Hare
145/
160
Deer
820/
895
Hare
190/
210
Deer
1080/
1185
Color modes (available only in XD series)
This menu option allows the user to switch from the standard mode
(“White Hot”) to one of the multiple color modes.
Press and hold down the controller (5) for two seconds to enter the
menu.
Rotate the controller to select menu option . Press the controller.
Rotate the controller to select one of the color modes, press the
controller to confirm.
After exiting the menu, the color mode selected by user becomes a
default mode and it is saved upon turning the unit off. When pushing the
“MODE” button for two seconds, color mode will switch to standard mode
“White Hot”, icon appears in the status bar.
For thermal imagers of the LD series, pushing the “MODE” button for two
seconds will switch standard mode “White Hot” to “Black Hot”, icon
appears in the status bar.
Color modes:
“White Hot”
“Red Hot”
“Red Monochrome”
“Rainbow”
“Ultramarine”
“Violet”
“Sepia”
To Next Page
Loading...
