6
Our Automatic Tool Start feature will start the vacuum for you
when you start your tool. Plug your tool into the Automatic
Tool Start and switch the power button to auto. When your tool
activates, the vacuum will turn on automatically. When the tool
turns off, the vacuum will run for 3 seconds to clear the hose
before it shuts off.
CAUTION:
It is important to consider the current draw (amp rating) of the tool you are
using with the ATS system. Tools should not exceed 15 amps. Depending on
the wall circuit it is possible that the combined draw of the vacuum and tool
could trip the circuit breaker. If the breaker trips look to see if any there are
any other devices on the circuit. If not discontinue using the ATS and nd
another outlet for the tool.
SERVICING YOUR PULSE
-
BAC
With regular use the Pulse-Bac® vacuum may require repair of critical components from time to time. This
section of your manual will provide information for a qualied technician to make repairs to the machine
when required. Most repairs to the machine can be made at your facility if the technician making the
repairs is trained in electrical and mechanical theory. If you are not qualied to repair the vacuum contact
Pulse-Bac Vacuums Service Department or have the unit returned to Pulse-Bac Vacuums™ or one of
Pulse-Bac Vacuums’s authorized service centers for repair. If you or someone you know is qualied to
service the unit and need assistance , contact the Pulse-Bac Vacuums Service Department and a qualied
technician will assist you to complete the repair.
Pulse-Bac Vacuums recommends that any repairs made to the valve system in the Pulse-Bac® be made
by Pulse-Bac Vacuums or a technician who is qualied to repair electro-mechanical equipment. If you or
someone you have retained plans to make repairs on your Pulse-Bac®, you will need the following tools
and test equipment:
Volt / Ohm Meter (digital or analog)
Phillips Screw Driver # 4 & # 3,
Needle Nose Pliers,
5/16 “ Nut Driver,
3/8” End Wrench
1/8” X 2” Slot Screw Driver.
To Next Page
Loading...
Need help?
General