PURE SIESTA iDock - Autotune; Listening to FM; Changing stations; Changing the information shown on-screen

5
EN
Listening to FM
Changing stations
When listening to FM there are two tuning modes, Manual and Seek (default):
Manual Pressing + or − tunes up or down in steps of 0.05 MHz
Seek Pressing + or − scans to the next/previous station.
By default, Siesta iDock is set to Seek.
To change the tuning mode, press Menu when listening to FM and select ‘FM tuning mode’.
FM Stereo mode
"$<7i
2[PbbXRP[\dbXR
'($<7i
BRP]]X]V
+
−
5<cd]X]V\^ST
<P]dP[Cd]T
Select Stereo (default) or Mono signal mode − Mono may improve audio clarity where stereo
signals are weak.
To switch between FM Stereo and Mono modes, Press Menu and select ‘FM stereo mode’.
5<bcTaT^\^ST
<^]^
Changing the information shown on-screen
Siesta iDock can display different information relating to the FM station you are listening to.
To change the information shown:
1. Press Menu and select ‘Display’.
2. Use the + and − keys to cycle through the following options (stations with RDS only):
Radio Text Scrolling text and information broadcast by the station.
Date The current date.
Autotune
If you lose a station signal, or wish to update your station list, you can perform an Autotune
to retune all DAB stations. Press Menu, then select ‘Autotune’.