insert blank lines in the front selected row as shown: «Delete this line» will delete the specified row.
«Return row selection» to return G command line to re-selected.
«Return the file selection» returns the file list interface.
Note: If the last instruction of the file is not able to run, in the final document to join a blank line! ! !
Panel Shortcuts as «origin Operation»
«Return to origin» Z-axis rise to Safe altitude, XY axis back to the origin, Z axis and then passed back to the origin.
«Return to the mechanical origin»: Z axis retreated mechanical origin, Y-axis retreated mechanical origin, Y-axis retreated mechanical origin, (please
note the configuration foot level and enable)
«Knife» Z-axis decreased (or increased), when it comes to the probe, please stop running then let the Z-axis coordinate is 0,and Z-axis carrying knives
to a safe altitude, the end of this process. (Please note that the configuration of the feet, the level and enable)
Panel shortcut to «coordinate cleanup operation.»
To Next Page
Loading...