What to do if the automatic float switch on the bilge pump raises but does not activate the pump on my PURSUIT C280 Boat?
Check if the in-line fuse near the battery switch has blown and replace the fuse if necessary. The pump impeller might be jammed by debris; clean the pump impeller housing.
General| Beam | 9 ft 6 in |
|---|---|
| Fuel Capacity | 200 gal |
| Water Capacity | 30 gal |
| Max Horsepower | 600 hp |
| Length | 28 ft 0 in |
| Draft | 2 ft 0 in |
Explains the meaning of DANGER, WARNING, CAUTION, and NOTICE symbols for hazard communication.
Proper engine lubrication for 4-cycle and 2-cycle engines, including oil type and level checks.
Explanation of audible alarm systems monitoring critical engine systems.
Explanation of the raw water cooling system and precautions for running the engine out of water.
Operation and importance of the engine stop switch and lanyard for safety.
Description of the hydraulic steering system, including helm assembly and cylinder.
Explanation of trim tab controls for adjusting hull attitude and side-to-side trim.
Information on carbon monoxide hazards, symptoms, and prevention.
List of safety equipment required by the U.S. Coast Guard.
Operation and importance of the engine stop switch and lanyard for safety.
Steps to perform before starting engines, including weather, documents, and safety equipment.
Detailed steps for winterizing the fresh water, raw water, air conditioner, and bilge systems.
Detailed safety instructions for fueling the boat, including fire and explosion hazards.
To Next Page