Why is my PVR PVL 25 motor protection tripping?
The motor protection may be tripping due to a pump seizure and jam, which requires a pump overhaul. Alternatively, it could be caused by a broken vane, in which case you should replace the vanes.
What causes oil leak in PVR Water Pump?
An oil leak could be caused by blocked exhaust filters, which means you should replace the oil separator (pos.45). It can also happen due to no lubrication, in which case the oil level needs filling up.
What to do if PVR Water Pump has drop in performances?
If your PVR Water Pump's performance is dropping, first eliminate any leaks. Also, check the oil level and conditions. If there's a lack of lubrication, fill with oil to the right level or replace the oil. If there is no lubrication see the previous point. Finally, a worn coupling element could be the cause, requiring a replacement.
How to fix anomalous noise in PVR PVL 25 Water Pump?
Anomalous noise in your PVR Water Pump can be due to several reasons: damaged motor or pump bearings (replace them), damaged vanes (replace them), or damaged contact surfaces (requires a pump overhaul at our workshop). It also might be caused by worn shaft oil seal rings, which you should replace (pos.14-15).
What causes discharge oil mist in PVR Water Pump?
Discharge oil mist can be caused by several issues: an inefficient oil separator (check and clean the oil recovery pipe, or replace oil separator (pos.45) if the oil recovery system or exhaust filters are inefficient or blocked), no lubrication (oil level filling up), pump seizure and jam (pump overhaul), or a broken vane (replace vanes).
How to deal with high temperature due to polluted oil in PVR PVL 25 Water Pump?
If your PVR Water Pump is experiencing high temperature due to polluted oil, perform an oil change.
How to reduce high operating temperature due to high ambient temperature in PVR Water Pump?
To decrease high operating temperature in your PVR Water Pump caused by high ambient temperature, decrease the room temperature by allowing a better air exchange.
How to clean dirty inlet filter in PVR Water Pump?
If the inlet filter of your PVR Water Pump is dirty, clean or replace it.
General| Brand | PVR |
|---|---|
| Model | PVL 25 |
| Category | Water Pump |
| Language | English |
To Next Page
