PVR EU 105 - User Manual

20 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

EU 105 - EU 105/B

Lubricated vane

vacuum pump

Operating and maintenance

instructions

EN

TRANSLATION

Publication Number:

LI 2246.03 January 2020

Questions and Answers

K
Kevin Warren MDAug 8, 2025
What to do if the motor protection is tripping on my PVR EU 105?
- C
  Christina FrancisAug 8, 2025
  If your PVR Water Pump's motor protection is tripping, it could be due to several reasons. It may be caused by pump seizure and jam, requiring a pump overhaul. Another possible cause is a broken vane, which means you should replace the vanes. Inefficient exhaust filters can also cause this problem, so replace them. Finally, high temperature due to polluted oil can cause the motor protection to trip, so you should change the oil.
P
Patty PowellAug 13, 2025
Why is there a drop in performance in my PVR EU 105 Water Pump?
- S
  Sarah PonceAug 13, 2025
  If you notice a drop in performance in your PVR Water Pump, several factors could be the cause. The inlet filters might be dirty, in which case you should clean or replace them. A blocked oil cooler can also lead to reduced performance, so clean or replace it. Lack of lubrication can also be the cause, so fill the pump with oil to the correct level, or change the oil and oil filter. Lastly, a worn coupling element can lead to performance issues, so replace it if necessary.
M
Michael SimonAug 16, 2025
How to fix an oil leak in my PVR EU 105?
- H
  hicksbrookeAug 16, 2025
  If your PVR Water Pump is leaking oil, there are several potential causes. The oil filling/discharge plugs might be leaking; check that the plug has been closed properly or replace the gasket. An inefficient oil recovery system could also be the cause, so check and clean the oil recovery pipe. Blocked exhaust filters can also lead to oil leaks, so replace them. Additionally, check the oil level.
J
Jeffery HicksAug 20, 2025
Why is my PVR Water Pump discharging oil mist?
- S
  Stefanie CameronAug 21, 2025
  If your PVR Water Pump is producing discharge oil mist, it could be due to a high operating temperature caused by a high ambient temperature. To resolve this, decrease the room temperature by allowing better air exchange. Also, check that the inlet valve is tight.
A
Ashley ChenAug 26, 2025
What causes oil to be found in the inlet circuit of my PVR EU 105?
- P
  Patrick JenkinsAug 26, 2025
  If you find oil in the inlet circuit of your PVR Water Pump, it's likely due to an inefficient inlet valve. Try cleaning the valve and replace any damaged parts.
C
Christine GarciaAug 29, 2025
What causes anomalous noise in my PVR EU 105 Water Pump?
- B
  Brittany WheelerAug 29, 2025
  If your PVR Water Pump is making anomalous noises, it could be due to several reasons. The motor or pump bearings might be damaged, requiring replacement. Damaged vanes can also cause unusual noises, so replace them. Damaged contact surfaces may be the issue, requiring a pump overhaul at our workshop. Finally, worn shaft oil seal rings can cause noise, so replace the oil seal rings.
S
Shawn DavisSep 3, 2025
How to fix leaking inlet pipes on a PVR EU 105?
- P
  Peter HallSep 3, 2025
  If the inlet pipes or the machine of your PVR Water Pump are leaking, identify the leaking point and seal it. Also, check the oil level and oil conditions.

PVR EU 105 Specifications

General

Brand	PVR
Model	EU 105
Category	Water Pump
Language	English

Related product manuals

Preview: PVR EU 105/B

Preview: PVR EU 160

Preview: PVR EU 45

Preview: PVR EU 205

Preview: PVR EM Series

Preview: PVR PVL 401 - PVL 401/B

PVR PVL 401 - PVL 401/B

Preview: PVR PVL 25/B