OPERATION
TURN ON/OFF THE UNIT
Press button (3) to turn on/off the unit.
DISPLAY TIME
Press CLK button (1) to show the time.
After 5 seconds it will return to show the
information.
SET THE CLOCK
Press and hold CLK button for 2 seconds.
The “HH” will flash. Using the knob (2)
(4) to change the hour. After that press
CLK button the “MM” will flash. Press the
knob (2) (4) to change the minute.
After that press CLK button to confirm. If
you don’t press CLK button to confirm. It
will writing here for your confirm.
AUXILIARY INPUT
The unit can be connected a portable audio
player through the AUX IN interface.
LOW BATTERY DISPLAY
When the battery of the car is lower below
10V around. It will show “LOW BAT”.
MEMORY FUNCTION
When B+ wire and Acc wire is off. It can
memory the radio’s preset stations.
RESET FUNCTION
RESET button (9) must be activated with
either a ballpoint pen or thin metal object.
The RESET button is to be activated for the
following reasons:
- Initial installation of the unit when all
wiring is completed.
- All the function buttons do not operate.
- Error symbol on the display.
Note: if press RESET button (9), the unit
can’t work yet, please use a cotton swab
soaked in isopropyl alcohol to clean the
socket on the front panel.
RADIO OPERATION
SWITCHING TO RADIO MODE
Press MODE button (7) to select radio
mode, the radio mode appears on the
display together with the memory band
and frequency.
SELECTING THE FREQUENCY BAND
At radio mode, press BND button (11)
shortly to select the desired band.
The reception band will change in the
following order:
→FM1→ FM2→ FM3→ AM1→AM2
SELECTING STATION
Press button (4) or button (2)
shortly to activate automatic seek
function. It will search up/down a station
automatically. Press for 2 seconds until
“MANUAL” appears on the display, the
manual tuning mode is selected. In this
mode you can turn up/down a step
frequency one by one till searched a
station. If both buttons have not been
pressed for several seconds, they will
return to seek tuning mode and “AUTO”
appears on the display.
MANUALLY STATION STORING
To receive a station, Press and hold the
button (5) for 2 seconds. It will
show “SAVE CH1”. If you want to store
the station to CH2. Shortly press it again
it will show “SAVE CH2”. In this moment
press and hold the button (5) for 2
seconds. The current station is stored
into the CH2.
PRESET STATIONS SELECTING
Press the button (7) shortly. You
can select the preset station (CH1~6).
To Next Page
Loading...
Need help?
General
