OPERATION
AUTOMATIC MEMORY STORING
Press BND button (11) for 2 seconds,
the radio searches from the 87.5MHz
frequency and checks the signal
strength until one cycle search is
finished. And then some stations are
stored into the corresponding preset
number button. In the first cycle it will
in LOCAL mode to receive the
stronger station. If it is less than 18
pcs station it will searching stations in
2
nd
cycle in DX (distance) mode.
USB PLAY OPERATION
On the back side of the unit, there is a USB
interface . You can connect an USB driver
through this interface . When you connect
an USB driver through the interface, the
unit will search the MP3 /WMA files in the
USB driver and start to play automatically. If
in other mode, you can also press MODE
button to select USB mode.
It supports the MP3/WMA file in the device.
SELECTING SONGS IN SINGLE STEP
Press button (4) or button (2) to
move to the following song or the previous
song. File number shows on display.
Press and hold button (4) or button
(2) for 2 seconds to fast forward or fast
reverse. Song playing starts from when you
release the button.
PAUSING PLAYING
Press button (5) to pause playing.
Press it again to resume playing.
SELECTING SONGS BY BND BUTTON
In USB mode. Press BND button (11) to
active the file search mode. It will show
“NUM *** ”. In this moment press VOL+ or
VOL- knob to select the song number’s 1’st
number. 3 seconds later to select the 2’nd
number... (Such as when you want to select
the 32’th song. In “NUM *** ” you press
VOL+ 3 times. It shows “NUM 3** ” And 3
seconds later the 2
nd
“*” flash. You can
press VOL+ 2 times. It shows “NUM 32* ” .
Then press button (5) to confirm. It will
start to play the 32’th song. But if you don’t
press button (5) to confirm. It will not
play the song you selected.
FOLDER+/- FUNCTION
When MP3/WMA playing. Press and hold
BND button it will back to the previous
folder. Press and hold MOD button it will to
the next folder.
CAUTION：
When there are important files in the USB
Device, do not connect it to the main unit to
play, because any wrong operation may
cause files loss. And our company
assumes no responsibility for this.
BLUETOOTH OPERATION
PRE-PAIR FOR BLUETOOTH
OPERATION
(i) When use Bluetooth, please make
sure the mobile phone supports
Bluetooth function.
(ii) For the different kind of mobile
phone, Bluetooth emissive power has
some difference. To get the best
conversation quality, it is commended
that the distance between the mobile
phone and the unit is within 3m. And
please don’t put any metal object or
any obstacle between the path of the
mobile phone and the unit.
PAIRING
1) On the mobile phone, select the
Bluetooth set up. (Please refer to the
instruction manual of your mobile
phone on how to operate Bluetooth.)
2) “CAR KIT” should appear in the list
To Next Page
Loading...
Need help?
General
