26
NOTE：
1) After the battery module is powered on, the soft-start function takes 3
seconds to activate. When the soft start is complete, the battery is ready
for high power output.
2) When connecting modules with different SOC/voltage in parallel during
expansion or replacement, it is recommended to maintain the system in
IDLE for ≥15 minutes or till the SOC LEDs become similar (≤1dot
difference) before normal operation.
5.10 Turning off
1) Turn external power source off.
2) Press red SW switch of master battery. Then all batteries will be off.
3) Turn Power Switch to OFF on master battery and all slave batteries.
4) Switch off the disconnection device between battery system and inverter,
if available.
To Next Page
Loading...
