Pyronix ATLAS 8 - System Option; Programmable Re-Sets

Page 22
11.11.3 System Option 1
Enter
followed by - . The RKP display will toggle ✔ and X as the numbered keys are pressed,
indicating the selection made.
Key Press
Display
1 2 3 4
Double Pole Zone User Log Reset
Enabled
Pulse Dial External and Internal
Sounders on Tamper
Activation
X
End Of Line Zones User Log reset
Disabled
Tone Dial Internal Sounder
Only On Tamper
Press to accept.
11.11.4 System Option 2
Enter
followed by - . The RKP display will toggle ✔ and X as the numbered keys are pressed,
indicating the selection made.
Key Press
Display
1 2 3 4
7 Day test dial Dial in Wide handshake filters Silent PA zones
X
24 Hour test dial No dial in Standard handshake filters Audible PA zones
Press to accept.
11.11.5 System Option 3
Enter
followed by - . The RKP display will toggle ✔ and X as the numbered keys are pressed,
indicating the selection made.
Key Press
Display
1 2 3 4
Engineer code NVM
Reset only
Display open zones
in day mode
Alarm on line fail Telephone line
monitoring disabled
X
Power down NVM
Reset
No display No alarm on line fail Telephone line
monitoring enabled
Press to accept.
11.11.6 System Option 4
Enter
followed by - . The RKP display will toggle ✔ and X as the numbered keys are pressed,
indicating the selection made.
Key Press
Display
1 2 3 4
Bell Squawk Bell time seconds No AC fail warning Spare
X
No Bell squawk Bell time minuets AC fail warning Spare
Press to accept.
11.11.7 Programmable Re-sets
Enter
HQWHUVHTXHQFH enter the number of re-sets required - ( = continuous re-setting)