Page 28
12 SYSTEM FAULTS
There are 6 fault conditions automatically detected by the Atlas 8. The user is informed of a fault via a flashing
!. This
will illuminate and an error tone will be emitted every 5 seconds when the panel is in day mode, Press a function key to
stop the error tone. The fault
! will remain on until the fault has been corrected.
To determine the fault go into the log by entering
the fault will be displayed.
Bell Fuse Failure
Auxiliary Fuse Failure
Battery Missing
Low Battery Voltage
Mains Failure
Telephone Line Failure
Spare
Event Report Failure
To Next Page
Loading...
