10
RADIO DEVICE
CONTROL?
Control Inputs?
Control Bells?
Learn Devices?
Select Bell
Available [1]
Select Bell
Learnt [2]
It is recommended that all wireless bells are learnt at
the Enforcer before any installation/mounting is done.
This makes learning much quicker.
A maximum of 2 wireless external bells (Deltabell WE)
can be connected to the Enforcer.
Even though the ‘learn’ may be successful, the
position of the bell box on a property must be tested
for signal strength before it is actually ‘xed’ into
place. Please see page 13 when analysing the
wireless range and signal strength.
Before learning each bell check that the battery is
present and is inserted correctly.
Follow the instructions to the right to start learning the
bells.
A bell that is learnt correctly will ash the GREEN LED
briey and display ‘Bell Learnt’ on the keypad. Both of
these instances need to occur to indicate a successful
learn.
D
A
B
C
SPACE
1
4
7 8
5
2
3
6
9
0
,/+.
ABC
JKL
MNO
PQRS
TUV
WXYZ
DEF
GHI
BYP
Green
Blue
Red
Learning...
Bell Learnt
Bell Learnt
Already!
Use
b
and
x
to scroll to:
Press
t
Press
x
Press
t
Press
t
Enter Bell.
Press
t
If ‘learnt’ is displayed on
a bell, this will need to be
deleted before learning
can begin. See page
12 for deleting bells.
When ‘Learning’ is
displayed, press and
hold the ‘LEARN’
button on the bell until
the LEDs cycle, then
release.
If the bell device is already
learnt on the Enforcer
system, ‘Bell Learnt
Already!’ will be displayed.
Press
t
Learning Bells
To Next Page
Loading...
Need help?
General
