To Next Page

To Previous Page

Specifications

The KF4-WE Buttons

KF4-WE Learning

Locking the Keyfob

1. Put the Enforcer control panel into the “Change Codes” menu

(see Enforcer User Manual for full details).

2. When prompted to enter a new user code, press any keyfob button.

3. Once asterisks appear on the Enforcer keypad, the new keyfob is learned on the system.

All 4 buttons on the keyfob may be locked so that any accidental presses won’t affect your alarm

system.

Locking the keys on the keyfob is performed by pressing any buttons that are diagonal with one

another at the same time: i.e. Lock & II or Unlock & I.

The RED LED will flash indicating that the fob has been locked.

To unlock, press both buttons together again, and the GREEN LED will flash indicating that the keyfob

is now unlocked.

Note: When locked, the LED status is disabled.

KF4-WE

4 Button, two way

RED BLUE GREEN

Status LED

Lock Button

Unlock Button

II Button

I Button

The batteries supplied have been chosen to

provide long service life whilst, for safety

reasons, having limited output current.

Replace only with approved batteries.

To prevent possible damage to components,

any static charge on your body needs to be

eliminated before touching the inside of the

unit. This can be accomplished by touching

some grounded/earthed metallic conductor

such as a radiator/pipework immediately

+ (Positive)

- (Negative)

CR-1/3N Li-Mn Cell (3 volts)

Transmission Frequency: 868MHz

Transmission Method: Fully encrypted rolling code

Transmission Range: 300m free space

Battery: CR-1/3N Li-Mn Cell (3 volts)

Battery Life: Up to 2 years

Operating Temperature: -10 to +40 °C

Emissions: EN55022 Class B

Immunity: EN50130-4

Dimensions: 60 x 40 x 15 mm

Weight: 28g