EasyManuals Logo
Home>Pyronix>Security System>Enforcer 32WE

Pyronix Enforcer 32WE Setup Guide

Pyronix Enforcer 32WE
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
24
Changing The Battery
KF4-WE
4 Button, two way
RED BLUE GREEN
RED BLUE GREEN
RED BLUE GREEN
RED BLUE GREEN
RED BLUE GREEN
Status LED
Lock Button
Unlock Button
II Button
I Button
The batteries supplied have been chosen to
provide long service life whilst, for safety
reasons, having limited output current.
Replace only with approved batteries.
To prevent possible damage to components,
any static charge on your body needs to be
eliminated before touching the inside of the
unit. This can be accomplished by touching
some grounded/earthed metallic conductor
such as a radiator/pipework immediately
+ (Positive)
- (Negative)
CR-1/3N Li-Mn Cell (3 volts)
Transmission Frequency: 868MHz
Transmission Method: Fully encrypted rolling code
Transmission Range: 300m free space
Battery: CR-1/3N Li-Mn Cell (3 volts)
Battery Life: Up to 2 years
Operating Temperature: -10 to +40 °C
Emissions: EN55022 Class B
Immunity: EN50130-4
Dimensions: 60 x 40 x 15 mm
Weight: 28g
Resetting the keyfob
To do a nvm reset on the keyfob, first remove the battery, then press and hold down the lock and unlock
buttons together and reinsert the battery at the same time. Continue holding down the buttons for
another 10 seconds and then release.

Other manuals for Pyronix Enforcer 32WE

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pyronix Enforcer 32WE and is the answer not in the manual?

Pyronix Enforcer 32WE Specifications

General IconGeneral
BrandPyronix
ModelEnforcer 32WE
CategorySecurity System
LanguageEnglish

Related product manuals