V2 TEL User Manual
Page: 17 Pyronix Ltd
CHAPTER 7: REMOTE CONTROL VOICE MENU
The V2 TEL remote control menu can be accessed in two different ways:
Method 1:
After acknowledging an alarm call at the end of the long beep, If the ‘9’ key is pressed
twice (99) the remote control menu is entered (if enabled by the engineer).
Method 2:
Call the V2 TEL telephone number. After a pre-programmed number of rings the V2 TEL
will answer-
The V2 TEL voice menu will ask you:
Enter your user code. This is the same code that is used to enter the user
menu on the V2 TEL.
After entering a valid user code the V2 TEL voice menu will say:
Enter your command number or press ‘9’ for help. The command
numbers available on the V2 TEL are as follows:
Press 1 = listen
Press 2 = talk
Press 3 = control output
Press 4 = system status
Press 0 = to hang up.
If you press 9 for help the following messages will be played:
Press 1 to listen, 2 to talk, 3 to control output, 4 for system status or
press 0 to hang up.
If you decided to control an output, press 3. The voice menu on V2 TEL will say:
Enter the output number. Enter the output that you wish to operate, 1 to 4
for the built in outputs (see the output appendix on page 18).
After choosing an output to control, the voice menu on V2 TEL will say:
Press ‘1’ to turn on, ‘0’ to turn off. This turns on and off the chosen
output.
If you decided to check the external system status, press “4” key. The V2 TEL will
say:
Armed or Disarmed. This function needs to be enabled by the Engineer.
To exit the V2 TEL voice menu press “0” key. The voice menu will say:
‘Goodbye’
To Next Page
Loading...
Need help?
General
