Page: 11
C H A P T E R 8 : U S I N G A T A G R E A D E R
If you have a tag reader installed, then it will be possible to set and unset the alarm system
using a tag (the same tags can also be used to arm/Unset via the keypad prox).
There are two types of readers that can be used with the Alarm System - the Internal Tag Reader
(used for indoors only) and the External tag reader (used for both indoors and outdoors).
Tags for the readers need to be programmed through the ‘Change Codes’ function in the Master
Manager Menu (see page 18). The internal and external readers can be both assigned to
individual level sets, this will need to be set up by your engineer.
Enabling the readers to the alarm system will be done by your engineer.
To set/unset the system using the Internal
Tag Reader, present a pre-programmed
tag to the tag symbol as shown.
The system will then set depending on the
type of exit mode programmed (Final
door, Timed or Push to set)
To set/unset the system using the external
Tag Reader, present a pre-programmed
tag to the centre of the prox.
The system will then arm depending on
the type of exit mode programmed (Final
door, Timed or Push to set)
To Next Page
Need help?
General
