Python 872 User Manual

Note
Remote Start Time-out Alert
During remote start a message is sent three minutes before and again
at one minute before the engine turns off. The f LED, Remote Start
LED flash and several tones play as an alert to reset the runtime if
desired.
Manual Transmission Start (MTS mode}
When installed into a manual transmission vehicle, the system requires
that
the MTS mode is properly set when parking. If MTS mode is not
properly
set or is defeated after being properly set the system will not
start
the engine.
l . With the engine running, set the parking brake and leave the
engine running.
For Pit Stop or Turbo Timer mode (to leave the
engine running after arming),
open the driver door.
2.
Release the foot brake (if pressed during Step l), or press and
release the foot brake anytime. As long as the engine is running
there
is no time limit to perform this step.
3.
Within 20 seconds of foot brake release, press any command
button on the remote, after
20 seconds return to Step 2 (For Turbo
Timer
Mode, press the optional dash mounted activation button
or send the Timer
Mode command.
4. The parking lights flash 5 times to confirm MTS mode enable and
the remote start activates the ignition outputs. The Remote Start
LED and On tones play to confirm.
5. Turn Off and remove the key from the ignition switch, the engine
remains running.
6. Exit the vehicle, close all the doors and arm the system.
© 2009 Directed Electronics. All rights reserved.
31

Python 872 Specifications

General

Brand	Python
Model	872
Category	Remote Starter
Language	English