Government
Regulations
This
device complies with
Part
15 of FCC
rules.
Operation
is
subject
to
the
fol-
lowing two conditions: (
1)
This
device may not cause harmful interference, and
(2)
This
device
must
accept any interference received,
including
interference
that may cause undesirable operation.
This
equipment
has
been tested and found
to
comply with the
limits
for a
class
B
digital device, pursuant
to
Part
15
of
the
FCC
Rules.
These limits are designed
to
provide reasonable protection against harmful interference
in
a residential
installation.
This
equipment generates and can radiate radio frequency
en-
ergy and, if not
installed and
used
in
accordance with the instruction manual,
may cause harmful interference
to
radio communications. However, there
is
no guarantee that interference
will not occur
in
a particular installation.
If
this
equipment does cause harmful interference
to
radio or television, which can be
determined by turning the equipment
OFF
and
ON,
the
user
is
encouraged
to
try
to
correct
the
interference by one or more of
the
following measures:
•
Reorient or relocate the receiving antenna.
• Increase
the
separation between
the
equipment and receiver.
•
Connect
the
equipment into
an
outlet
on
a circuit different from that to which
the
receiver
is
connected.
• Consult
the
dealer
or
an experienced radio /
TV
technician for help.
Remote
Controls
To
satisfy FCC
RF
exposure compliance requirements,
this
device should be
used
in
hand-held, hand operated configurations only.
The
device and
its
an-
tenna
must
maintain a separation distance of
20
em
or more from
the
person's
body, except for
the
hand and wrists,
to
satisfy
RF
exposure compliance.
This
device
is
designed to be
used
in
a person's hands and
its
operating configu-
rations
do
not support normal transmissions while
it
is
carried
in
pockets or
holsters
next to a person's
body
.
44
© 2009
Directed
Electronics.
All
rights
reserved.
To Next Page
Loading...
Need help?
General
