Python 872 User Manual

Valet Mode
Valet mode con be entered and exited by performing the Remote Valet
command or manually using the vehicle key and
the control button.
When entered, the alarm functions ore defeated while the conve-
nience features
still operate normally.
Arm
and Disarm commands lock and unlock the doors. The Responder
LE emits the Arm in Valet and Disarm in Valet output as described for
Arm
and Disarm in the Basic Commands section.
Use the following steps to manually enter and exit Valet
Mode:
l . Turn the ignition switch On and then Off
2. Immediately press and release the control button once
3.
The control center LED turns On when entering and Off when
exiting.
Power Save
To reduce power consumption the control center status LED modifies
its output if the vehicle is parked for on extended period. If Armed the
flashing is reduced after 24 hours. When Valet mode is On the LED
will turn off l hour and will reset each time the ignition is turned off.
Rapid Resume
If power is ever disconnected by a mechanic or thief, the system will
resume the state
it was in at the time of disconnection, when power
is reconnected.
Automatic Remote Updates
The system sends a silent message to all remote controls after any
major action has occurred. When the remote receives this message it
updates
the Arm status.
© 2009 Directed Electronics. All rights reserved.
35

Python 872 Specifications

General

Brand	Python
Model	872
Category	Remote Starter
Language	English