7.
The engine
turns
off
and
after a
few
seconds, the Remote Start
LED
and
Off
tones
play
to confirm.
If
the
door
is
opened
in
Step
3 then
the
engine continues to
run.
Turbo
Timer
Mode
The
system
keeps the engine running for the Turbo Timer runtime
and
can
be
activated
by
remote control or optional dash mounted activa-
tion button.
l .
With
the engine running,
set
the parking broke.
2.
Press
the
optional dash mounted activation button or perform the
Timer
Mode
command.
3. The parking lights
turn
on
and
the remote start activates
the
igni-
tion outputs. The Remote Start
LED
and
On
tones
play
to con-
firm.
4.
Turn
Off
and
remove
the key from the ignition switch, the engine
. .
rema1ns
runnmg.
5.
Exit
the vehicle,
close
all the doors
and
arm the system.
6.
The engine
runs
for the Turbo
Mode
runtime.
Note
Remote
Start
Faults
For
user safety, the
system
must
be
properly configured or remote start
will not activate. The Remote Start Fault output (
f
LED
on and long
fault tone) may be caused
by
any
of
several configuration
issues.
Refer
to
the following table for the command type
and
parking light flashes
that
will
identify the configuration issue
and
solution.
32
©
2009
Directed Electronics.
All
rights reserved.
To Next Page
Loading...
Need help?
General
