(1) PASSWORD CHANGE
·6-DIGIT
PASSWORD
·DEFAULT
PASSWORD
SETTING:
111111
When you select “CHANGE PASSWORD”, the menu below will
open.
1. Press the channel 1 button six times.
2. Once you have input the current password, you can set a new
password.
3. Then confirm the password you have set.
·You can use a combination of any of the buttons, except the [MENU]
button on the front of your DVR to set a new password
·When the new password is accepted the following screen message will
flash: “Password changed”
·The message will blink 3 times. Then the “MENU” will return. If the
password is not accepted you will receive a message that informs you
that it was not accepted and the “MENU” returns. You may try again
by repeating the same steps.
NOTICE: The Factory Default Password is 111111.This number
(1) Corresponds with the button for camera “one” on the front of
your DVR.
-23-
To Next Page
Loading...
