Chapter 4. Hardware Installation
A. Connecting DVR to Your TV Set
(1) Video Input/Output Connection (For TV monitor screen display)
Any TV set that has a “RCA Video Input” terminal is suitable for displaying the
picture. The figure below shows the video signal line connection.
<“Video in” on TV>
Using a RCA cable, connect “VIDEO IN” on your TV to “VIDEO OUT ” on the
rear panel of the DVR.
Notice: You need to purchase a RCA cable separately for connecting to the
Video In port on the TV. A RCA female to BNC male adapter is provided for
connecting the cable to the Video Out port of the DVR.
(2) Audio Input/output connection(For TV speaker)
<“Audio in”of TV>
Using an RCA cable, connect “AUDIO IN” of your TV to “AUDIO OUT” port
on the rear panel of the DVR.
Notice: You need to purchase a RCA cable separately for connecting to the
Audio In port on the TV.
-6-
To Next Page
Loading...
