QBC STAR™ System User’s Manual
2–10 L–000867(A)
External Printer
External Printer lets you enable or disable a printer that would be attached to the printer port on
the back of the instrument. It also lets you enable or disable color printing to the external printer.
When you select the option, a sub-menu titled “EXTERNAL PRINTER” appears.
Enable/Disable External Printer
When the printer is ENABLED, the menu lets you disable the printer by selecting option 1.
External printing is disabled by default. When the printer is enabled, option 1 reads “Disable
Printer.” You can disable the printer by confi rming that the arrow cursor (
option 1 and pressing the
key. A message appears stating “External Printer Is Disabled.”
, you can enable it by selecting option 1. When the printer is
disabled, option 1 reads “Enable Printer.” You can enable the printer by confi rming that the
) is pointing to option 1 and pressing the
key. A message appears stat-
ing “External Printer Is Enabled.”
Enable/Disable Color Printing
When color printing is ENABLED, the menu lets you disable it by selecting option 2. Color print-
ing is enabled by default. When color printing is enabled, option 2 reads “Disable Color.” You
can disable color printing by confi rming that the arrow cursor (
) is pointing to option 2
key. A message appears stating “Color Disabled.”
, you can enable it by selecting option 2. When color printing
is disabled, option 2 reads “Enable Color.” You can enable color printing by confi rming that
) is pointing to option 2 and pressing the
SI/STD Units
SI/STD Units lets you select whether certain results are reported in SI units (millimoles per Liter) or
STD units (grams per deciLiter). The results that are affected are: Hemoglobin and MCHC.
When SI units are selected, menu option 4 reads “STD Units.” You can select STD units by using
key to move the arrow cursor (
) up or down the list until it is pointing to option
on the keypad. A message appears stating “STD Units Selected.”
When STD units are selected, menu option 4 reads “SI Units.” You can select SI units by using the
key to move the arrow cursor (
) up or down the list until it is pointing to option 4.
on the keypad. A message appears stating “ SI Units Selected.”
To Next Page