- 8-
Connect tile saw as close as possible to power source.
TO AVOID PERMANENT MOTOR DAMAGE YOU MUST USE THE CORRECT
EXTENSION CORD. NEVER USE MORE THAN ONE EXTENSION CORD AT A TIME.
TROUBLESHOOTING
Overheating of saw:
A. Turn saw off and let it rest until motor is cool to the touch.
B. Check and clean the ventilation slots, removing blockage and dirt.
The saw does not start:
A. Check that power cord is properly plugged in.
B. No power from outlet.
C. Switch is damaged.
120 VOLT MOTOR SPECIFICATIONS
Volts 120 V
Cycle 60 CYCLE
RPM n
0
3600 RPM
Amps/Watts 1.5 Amps
ELECTRICAL AND MOTOR SPECIFICATIONS
To Next Page
Loading...
