A – Command Line Interface
Set Config Command
A-44 59226-00 B
S
FDMIEntries The number of device entries to maintain in the FDMI
database. Enter a number from 0–1000. The default is
1000.
DefaultDomainID Default domain ID. The default is 1.
DomainIDLock Prevents (True) or allows (False) dynamic reassign-
ment of the domain ID. The default is False.
SymbolicName Descriptive name for the switch. The name can be up
to 32 characters excluding #, semicolon (;), and
comma (,). The default is SANbox.
R_A_TOV Resource Allocation Timeout Value. The number of
milliseconds the switch waits to allow two ports to allo-
cate enough resources to establish a link. The default
is 10000.
E_D_TOV Error Detect Timeout Value. The number of millisec-
onds a port is to wait for errors to clear. The default is
2000.
PrincipalPriority The priority used in the FC-SW-2 principal switch
selection algorithm. 1 is high, 255 is low. The default is
254.
ConfigDescription Switch configuration description. The configuration
description can be up to 32 characters excluding #,
semicolon (;), and comma (,). The default is
Config Default.
InteropMode Propagates just the active zone set throughout the fab-
ric (Standard, FC-SW-2 compliant) or the entire zoning
database (Interop-1, non-compliant). The default is
Standard.
LegacyAddressFormat Available only when the InteropMode parameter is
Interop-1, this parameter enables (True) or disables
(False) the use of legacy address formatting for inter-
operating with non-FC-SW-2 switches. The default is
False.
Table A-10. Set Config Switch Parameters (Continued)
Parameter Description
To Next Page
Loading...
Need help?
General
