Qlogic SANbox 1400 Series

A – Command Line Interface
Show Perf Command
A-86 59226-00 B
S
Examples The following is an example of the Show Perf command:
SANbox #> show perf
Port Bytes/s Bytes/s Bytes/s Frames/s Frames/s Frames/s
Number (in) (out) (total) (in) (out) (total)
------ ------- ------- ------- -------- -------- --------
0 7K 136M 136M 245 68K 68K
1 58K 0 58K 1K 0 1K
2 0 0 0 0 0 0
3 0 0 0 0 0 0
4 0 0 0 0 0 0
5 0 0 0 0 0 0
6 0 7K 7K 0 245 245
7 136M 58K 136M 68K 1K 70K
8 7K 136M 136M 245 68K 68K
9 58K 0 58K 1K 0 1K
The following is an example of the Show Perf Byte command:
SANbox $> show perf byte
Displaying bytes/sec data... (Press any key to stop display)
0 1 2 3 4 5 6 7 8 9
-----------------------------------------------------------------------------
76M 0 0 22M 0 0 0 33M 0 20
78M 0 0 24M 0 0 0 33M 0 21
78M 0 0 24M 0 0 0 33M 0 21
77M 0 0 23M 0 0 0 34M 0 20
77M 0 0 23M 0 0 0 34M 0 20
84M 0 0 30M 0 0 0 33M 0 21
83M 0 0 29M 0 0 0 33M 0 21
80M 0 0 25M 0 0 0 35M 0 20
77M 0 0 23M 0 0 0 34M 0 20
78M 0 0 23M 0 0 0 34M 0 21
75M 0 0 19M 0 0 0 35M 0 21
74M 0 0 18M 0 0 0 36M 0 21
q