Need help?Do you have a question about the QNAP HS-453DX and is the answer not in the manual?
Provides information on the QNAP HS-453DX NAS and instructions for installation, basic operations, and troubleshooting.
Intended for consumers and storage administrators with a basic understanding of storage and backup concepts.
Explains symbols used in the guide, including notes, important notes, tips, and warnings.
Provides basic information about the QNAP HS-453DX NAS, its processor, memory, and connectivity features.
Details the technical specifications of the HS-453DX, including CPU, memory, storage, and network ports.
Identifies and describes the components located on the front panel of the HS-453DX NAS.
Identifies and describes the components located on the rear panel of the HS-453DX NAS.
Details the components found on the system board of the HS-453DX NAS, including CPU and memory slots.
Illustrates the numbering scheme for the front drive bays of the HS-453DX NAS.
Provides essential instructions for ensuring personal safety and environmental safety during NAS operations.
Specifies the environmental, hardware, and tool requirements for setting up the HS-453DX NAS.
Provides an overview of the steps involved in setting up the HS-453DX NAS, including drive installation and QTS setup.
Provides information on installing drives and replacing memory modules in the HS-453DX NAS.
Explains how to install 3.5-inch and 2.5-inch drives, and M.2 SSDs into the HS-453DX NAS.
Step-by-step guide for installing 3.5-inch hard drives into the HS-453DX NAS drive trays.
Step-by-step guide for installing 2.5-inch drives into the HS-453DX NAS drive trays.
Step-by-step instructions for installing M.2 SSDs into the HS-453DX NAS.
Detailed guide on how to replace or upgrade the memory modules in the HS-453DX NAS.
Information about pre-installed thermal pads on the HS-453DX for cooling and when to replace them.
Step-by-step instructions for replacing thermal pads on the CPU, MOSFET, and 10 GbE ICs.
Recommended method for installing QTS using Qfinder Pro on a local network.
Method for installing QTS over the internet using a myQNAPcloud account and Cloud Key.
Method for installing QTS using an HDMI connection and a monitor.
Detailed steps for installing QTS via Qfinder Pro, including system configuration and disk setup.
Step-by-step guide to install QTS using a Cloud Key and myQNAPcloud account.
Procedure for installing QTS using an HDMI monitor, USB keyboard, or IR remote control.
Describes how to power on, power off, and force power off the HS-453DX NAS using the power button.
Explains the procedures for basic and advanced system resets using the reset button.
Explains the meaning of the System Status and Drive LEDs, their status, and associated descriptions.
Details the different beep durations, frequencies, and their corresponding descriptions for system events.
Steps to troubleshoot issues where Qfinder Pro or myQNAPcloud cannot locate the NAS.
Procedure for replacing failed drives in the NAS without powering it off.
Provides links to QNAP's documentation, helpdesk, downloads, and community forum for support.
Defines key terms used in the user guide, such as CloudKey, CloudLink, myQNAPcloud, Qfinder Pro, and QTS.
Outlines QNAP's limited warranty service for hardware products, including the warranty period.
States QNAP's disclaimers regarding product use, liability, warranties, and potential data loss.
Provides FCC Class B compliance information, including conditions for operation and potential interference.
States that the QNAP NAS complies with CE Compliance Class B standards.
General| Flash memory | 4096 MB |
|---|---|
| Memory slots | 2 |
| Internal memory | 4 GB |
| Internal memory type | DDR4 |
| Maximum RAM supported | 8 GB |
| Tjunction | 105 °C |
| Processor cache | 4 MB |
| Processor cores | 4 |
| System bus rate | - GT/s |
| Processor family | Intel® Celeron® |
| Processor socket | BGA 1090 |
| Processor codename | Gemini Lake |
| Processor frequency | 1.5 GHz |
| Processor lithography | 14 nm |
| Processor manufacturer | Intel |
| Processor package size | 25 x 24 mm |
| CPU configuration (max) | 1 |
| Conflict-Free processor | Yes |
| PCI Express slots version | 2.0 |
| Processor boost frequency | 2.5 GHz |
| Processor operating modes | 64-bit |
| ECC supported by processor | No |
| PCI Express configurations | 1x2, 1x2+2x1, 1x4, 2x1, 4x1 |
| Thermal Design Power (TDP) | 10 W |
| On-board graphics card model | Intel® UHD Graphics 600 |
| On-board graphics card ID | 0x3185 |
| On-board graphics card base frequency | 250 MHz |
| On-board graphics card DirectX version | 12.0 |
| On-board graphics card dynamic frequency (max) | 750 MHz |
| Number of displays supported (on-board graphics) | 3 |
| RAID levels | 0, 1, 5, 6, 10, JBOD |
| Storage drive size | - \ |
| Storage drive capacity | 0 GB |
| Supported file systems | FAT32, HFS+, NTFS, exFAT, ext3, ext4 |
| Storage drive interface | - |
| Storage drive sizes supported | 2.5, 3.5 \ |
| Supported storage drive types | HDD & SSD |
| Total installed storage capacity | 0 TB |
| Number of storage drives installed | 0 |
| Supported storage drive interfaces | M.2, Serial ATA III |
| HDMI version | 1.4b/2.0 |
| USB 2.0 ports quantity | USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them. |
| Ethernet LAN data rates | 10, 100, 1000, 2500, 5000, 10000 Mbit/s |
| Supported network protocols | TCP/IP, HTTP/HTTPS |
| Type | NAS |
| Noise level | 13 dB |
| Device class | Home & Home Office |
| Share folder | CIFS/SMB |
| Backup features | Cloud, iSCSI LUN |
| Browser supported | Apple Safari 7+, Google Chrome, Microsoft Internet Explorer 10+, Mozilla Firefox |
| Noise level (idle) | 6.2 dB |
| Security algorithms | 256-bit AES, FIPS 140-2, HTTPS, SSH |
| Chassis type | Tower |
| Product color | Gold, White |
| LED indicators | Status |
| Number of fans | 0 fan(s) |
| AC input voltage | 100 - 240 V |
| Power supply location | Built-in |
| Power consumption (sleep) | 13.55 W |
| Power consumption (typical) | 22.38 W |
| Power supply unit (PSU) capacity | 90 W |
| Operating temperature (T-T) | 0 - 35 °C |
| Operating relative humidity (H-H) | 5 - 95 % |
| Operating system installed | QNAP Turbo System |
| Mac operating systems supported | Mac OS X 10.10 Yosemite, Mac OS X 10.11 El Capitan, Mac OS X 10.12 Sierra, Mac OS X 10.13 High Sierra, Mac OS X 10.14 Mojave, Mac OS X 10.7 Lion, Mac OS X 10.8 Mountain Lion, Mac OS X 10.9 Mavericks |
| Server operating systems supported | Windows Server 2003, Windows Server 2008 R2, Windows Server 2012, Windows Server 2012 R2, Windows Server 2016 |
| Windows operating systems supported | Windows 10, Windows 10 Education, Windows 10 Education x64, Windows 10 Enterprise, Windows 10 Enterprise x64, Windows 10 Home, Windows 10 Home x64, Windows 10 IOT Core, Windows 10 Pro, Windows 10 Pro x64, Windows 7, Windows 7 Enterprise, Windows 7 Enterprise x64, Windows 7 Home Basic, Windows 7 Home Basic x64, Windows 7 Home Premium, Windows 7 Home Premium x64, Windows 7 Professional, Windows 7 Professional x64, Windows 7 Starter, Windows 7 Starter x64, Windows 7 Ultimate, Windows 7 Ultimate x64, Windows 7 x64, Windows 8, Windows 8 Enterprise, Windows 8 Enterprise x64, Windows 8 Pro, Windows 8 Pro x64, Windows 8 x64 |
| Cables included | AC, LAN (RJ-45) |
| Number of screws | 16 |
| Number of execution units | 12 |
| Maximum number of PCI Express lanes | 6 |
| Memory types supported by processor | DDR4-SDRAM, LPDDR4-SDRAM |
| Memory channels supported by processor | Dual |
| Intel Smart Response Technology version | 0.00 |
| Intel Identity Protection Technology version | 1.00 |
| Processor ARK ID | 128989 |
Weight and Dimensions| Depth | 220 mm |
|---|---|
| Width | 404 mm |
| Height | 42.8 mm |
| Weight | 2400 g |
To Next Page
