Need help?Do you have a question about the QNAP HS-210 and is the answer not in the manual?
Danger of explosion if battery is incorrectly replaced. Use only manufacturer-recommended types.
Do NOT touch the fan inside the system to avoid serious injuries.
QNAP NAS comply with different FCC compliance classes.
This device complies with Part 15 of the FCC Rules.
This equipment complies with limits for a Class B digital device.
QNAP NAS comply with different CE compliance classes.
This icon indicates instructions must be strictly followed for safety.
This icon indicates actions that may lead to data or product damage.
Press to turn on or turn off the NAS.
Press to reset the system settings.
Press reset for 3 seconds; a beep sound confirms reset.
Press reset for 10 seconds; two beeps confirm advanced reset.
NAS supports instant data backup via front USB port.
LED indicators show system status and information.
Describes LED behavior for network connectivity.
Indicates disk access, errors, and status.
Shows status of USB and eSATA device connections.
Provides descriptions for different beep sounds and their causes.
Instructions for upgrading RAM on TS-453Bmini models.
Instructions for upgrading RAM on TBS-453A models.
Instructions for upgrading RAM on TS-451S and related models.
Instructions for upgrading RAM on TVS-473 models.
Details compatibility of network cards with expansion brackets.
Procedure for installing a network card in TS-1635.
Procedure for installing a network card in TVS-473 models.
Procedure for installing a network card in TS-431XU models.
General steps for installing hard drives into the NAS.
Specific procedure for installing HDDs in TS-1635.
Specific procedure for installing HDDs in TS-453Bmini.
Specific procedure for installing HDDs in TVS-473 models.
Lists NAS models supporting hot-swap for different drive types.
Instructions for installing heat sinks on M.2 SSD controllers.
General procedure for installing M.2 SSDs.
Specific procedure for installing M.2 SSDs on TBS-453A.
Specific procedure for installing M.2 SSDs on TVS-473 models.
Steps to recover a RAID group after drive failure.
Navigating and using the NAS LCD panel.
How to view IP addresses using the LCD panel.
Steps to configure settings like TCP/IP, Password via LCD.
Detailed steps for TCP/IP settings on LCD panel.
Procedure for installing a hot-swappable PSU in 1U Turbo NAS.
Procedure for replacing PSU in 2U/3U Turbo NAS models.
Warning regarding high voltage connectors on the back panel.
Provides links to QNAP online support and forums.
Contact information for technical support in North America.
Lists NAS models categorized by FCC and CE compliance.
To Next Page
General
