What to do if Qfinder Pro or myQNAPcloud can't locate my QNAP Storage?
If Qfinder Pro or myQNAPcloud fails to locate your QNAP NAS, the drives or data may be faulty. Here's what you should do: 1. Power off the NAS. 2. Remove all the drives. 3. Power on the NAS. 4. Try to locate the NAS using Qfinder Pro or myQNAPcloud again.
How to hot-swap failed drives on QNAP Storage?
To hot-swap failed drives on your QNAP device, follow these steps: 1. Log on to QuTS hero. 2. Go to Main Menu > Storage & Snapshots > Storage > Disks/VJBOD. 3. Locate the failed drive. 4. Prepare a new hard drive with the same or larger capacity than the failed one. 5. Remove the failed drive from the device. 6. Wait for 20 seconds or until the device beeps twice. 7. Remove the failed drive from the drive tray. 8. Insert the new drive into the drive tray. 9. Install the new drive. The NAS will beep twice. 10. Go to Main Menu > Storage & Snapshots > Storage Space. 11. Locate the shared folder containing the new drive and verify its status is Rebuilding.
General| Model | TS-h1886XU-RP-R2 |
|---|---|
| Category | Storage |
| Form Factor | Rackmount |
| Total Drive Bays | 18 |
| CPU Architecture | 64-bit |
| Maximum Memory | 128 GB |
| Hot-swappable | Yes |
| SSD Cache Acceleration Support | Yes |
| 2.5 Gigabit Ethernet Port (RJ45) | 2 |
| Drive Bay Types | 12 x 3.5-inch + 6 x 2.5-inch |
| Drive Compatibility | 3.5" SATA HDD/SSD, 2.5" SATA SSD |
| GPU | Integrated Intel UHD Graphics |
| Memory | 16 GB DDR4 |
| Memory Slot | 4 x DDR4 UDIMM slots |
| Flash Memory | 5GB (Dual boot OS protection) |
| M.2 SSD Slot | 2 |
| 10 Gigabit Ethernet Port | 2 |
| Network Interfaces | 2 x 10GbE |
| PCIe Slots | 2 |
| USB 3.2 Gen 2 (10Gbps) Port | 2 |
| Power Supply Unit | 500W |
| RAID Support | RAID 0, 1, 5, 6, 10, 50, 60, JBOD |
To Next Page