QNAP QSW-M408 Series User Manual

The QSW-M408 series supports DHCP client by default. When connected to a network, the switch will obtain an
IP address from a DHCP server automatically. You can then use Qfinder to locate the switch and access the web
user interface.
If your network is not connected to a DHCP server, you can access the web user interface by changing your
computer
’s IP address to 169.254.100.102.
The default IP address of the QSW-M408 is 169.254.100.101
Default username: admin
Default password: same as MAC Address
When logging in for the first time, you will be prompted to set a new username and password. QNAP
strongly recommends setting a new username and password for security purposes.
Note: After conguration, ensure that you change your computer’s IP address back to the original setting.
Accessing the Web User Interface
Web User Interface Login
1 3 5 7
11 12
SFP+
SFP+
SFP+
SFP+
2 4 6 8 9 10
1
3
2 4
LED Status Description
System Status
Flashing Device is booting.
Green Device is booted.
O Device is powered o.
RJ45
Green (Left) Link is operating at 1 Gbps.
Amber (Right) Link is operating at 100/10 Mbps.
Flashing Network is active.
O No link.
SFP+
Green Link is operating at 10/1 Gbps.
Flashing Network is active.
O No link.
SFP+/RJ45 Combo
Green (SFP+) Link is operating at 10/1 Gbps.
Green (RJ45) Link is operating at 10 Gbps.
Amber (RJ45)
Link is operating at
5Gbps/2.5Gbps/1Gbps/100Mbps.
Flashing Network is active.
O No link.
LED Behavior
EN

QNAP QSW-M408 Series Specifications

General

Brand	QNAP
Model	QSW-M408 Series
Category	Switch
Language	English