Note
• The at head M3x5 screws require a Phillips #2 screwdriver.
• A torque of 7 kgf.cm (6.08 lbf.in) ± 0.5 kgf.cm (0.43 lbf.in) is recommended for
electric screwdrivers.
b. Pull the LED circuit board away from the chassis.
19. Remove the LCD display module from the chassis.
a. Remove the screws that secure the LCD display module to the chassis.
Note
• The at head M2.5x4 screws require a Philips #1 screwdriver.
• A torque of 3 kgf.cm (2.60 lbf.in) ± 0.5 kgf.cm (0.43 lbf.in) is recommended for
electric screwdrivers.
| NAS Repair Manual
Category C NAS Models 76
To Next Page
Loading...
Need help?
General
