EasyManuals Logo

QNAP TS-231 User Manual

QNAP TS-231
135 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #71 background imageLoading...
Page #71 background image
71
recognized by the operating system, log into QTS as administrator and go to
“Control Panel” > “System Settings” > “System Status” > “Network Status” and
check for total number of network interfaces.
6.3 TVS-473, TVS-673, TVS-873
Note:
1. TVS-473 uses low-profile PCIe bracket.
3. TVS-673 and TVS-873 use full height PCIe bracket.
1. Turn off the NAS. Disconnect power cord(s), network cable(s), and any other cables
attached to the device.
2. Before opening the NAS, wear an antistatic wrist strap and connect the crocodile
clamp to ground to prevent electrostatic discharge from damaging equipment.
3. Loosen and remove the screws on the back of the NAS that are connecting the case
cover to the case.
4. Gently remove case cover from case.

Table of Contents

Other manuals for QNAP TS-231

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the QNAP TS-231 and is the answer not in the manual?

QNAP TS-231 Specifications

General IconGeneral
Flash Memory512MB
Drive Bays2
LED IndicatorsStatus, LAN, USB, HDD1, HDD2
Form FactorTower
Power SupplyExternal Power Adapter, 60W, 100-240V
CPUAnnapurna Labs Alpine AL-212 1.7 GHz dual-core
RAM512MB DDR3
Maximum Internal Raw Capacity16TB (2 x 8TB HDD)
Network Interface1 x Gigabit RJ45 Ethernet port
ButtonsPower, Reset
Weight1.28 kg
Fan1 x 70 mm, 12V DC
Operating SystemQTS (Embedded Linux)
Power Consumption (In Operation)15.6W
USB Ports2 x USB 3.0

Related product manuals