Need help?Do you have a question about the QNAP TS-853U-RP and is the answer not in the manual?
General| Model | TS-853U-RP |
|---|---|
| Category | Network Storage Server |
| Form Factor | 2U Rackmount |
| Total Drive Bays | 8 |
| Flash Memory | 512MB DOM |
| HDMI Output | Yes |
| Compatible Drive Type | 3.5" SATA HDD, 2.5" SATA HDD/SSD |
| CPU | Intel Celeron J1900 |
| RAM | 4GB DDR3L |
| Maximum Memory | 8GB |
| Operating System | QTS |
| Supported Protocols | CIFS, AFP, NFS, FTP, WebDAV |
| Dimensions (HxWxD) | 88 x 482 x 452 mm |
| Maximum Raw Capacity | 64 TB (8 x 8 TB HDD) |
| Ethernet Ports | 4 x Gigabit RJ-45 |
Device compliance with FCC Part 15 rules for Class A digital devices.
Device compliance with FCC Part 15 rules for Class B digital devices.
Instructions for upgrading memory in TS-453Bmini and TS-453mini models.
Instructions for upgrading memory in the TBS-453A model.
Memory upgrade for various TS and TVS series models.
Instructions for upgrading memory in the TS-1635 model.
Memory upgrade procedures for TVS-473, TVS-673, and TVS-873.
Memory upgrade for TS-431U and related series models.
Memory upgrade for TS-251 and TS-451 series models.
RAM module installation for the IS-453S model.
Installing network cards in specific QNAP NAS models.
Network expansion card installation for the TS-1635 model.
Installing network expansion cards in TVS-473, TVS-673, TVS-873.
Network expansion card installation for TS-431XU and related series.
Network expansion card installation for TS-831XU and related series.
Procedures for installing hard drives into various QNAP NAS models.
Hard drive installation for a wide range of QNAP NAS models.
Installing hard drives in the TS-1635 model.
Hard drive installation for TS-453Bmini and TS-453Mini.
Hard drive installation for TVS-473, TVS-673, and TVS-873.
Hard drive installation for TS-112P, TS-212P, and TS-251C.
Hard drive installation for TAS and TS series models.
Installing hard drives into the IS-453S model.
Procedures for hot-swapping hard drives in compatible QNAP NAS models.
Installing heat sinks onto M.2 SSD controllers for reliable operation.
Procedures for installing M.2 SSDs in compatible QNAP NAS models.
Installing M.2 SSDs on the TBS-453A model.
M.2 SSD installation for TVS-473, TVS-673, and TVS-873.
Using the LCD panel to configure settings and view system information.
How to view the NAS model name and IP addresses via the LCD panel.
Navigating the LCD panel menu to configure system settings.
Instructions for installing a redundant power supply unit in 1U Turbo NAS.
Replacing a failed power supply unit in 2U/3U Turbo NAS models.
To Next Page
