Installing 2.5-inch Hard Drives or Solid State Drives
Warning
• Installing a drive deletes all data on the drive.
• Observe electrostatic discharge (ESD) procedures to avoid damage to components.
1. Power off the NAS.
2. Remove drive tray.
a. Pull the tray handle forward.
b. Pull the tray out.
3. Install a drive on the tray.
a. Place the drive on the tray so that the holes on the bottom of the drive are aligned with the holes
on the bottom of the tray.
b. Attach the screws to lock the drive to the tray.
TS-431X User Guide
Installation and Configuration 12
To Next Page
Loading...
