QNAP TVS-73e Series - 3. Installation and Configuration; Hardware Installation; Drive Installation; Installing 3.5-inch Hard Drives on 3.5-inch Trays

3.
Installation and Configuration
This chapter provides specific hardware a
Hardware Installation
This section provides information on installing drives, memory modules, and expansion cards.
Drive Installation
The TVS-
x73e is compatible with 3.5
state drives.
Installing 3.5-
inch Hard Drives on 3.5
Warning
•
Installing a drive deletes all data on the
•
Observe electrostatic discharge (ESD) procedures to avoid damage to
1. Power off the NAS.
2. Remove the drive tray.
a. Slide the lock down.
b.
Pull the handle to release the
c. Pull the tray out.
3. Install a drive on the drive
tray.
a.
Remove the fastening panels from the sides of the
Installation and Configuration
Installation and Configuration
This chapter provides specific hardware and operating system installation and configuration steps.
This section provides information on installing drives, memory modules, and expansion cards.
x73e is compatible with 3.5
-inch and 2.5-inch hard drives, 2.5-
inch solid state drives, and M.2 solid
inch Hard Drives on 3.5
-inch Trays
Installing a drive deletes all data on the
drive.
Observe electrostatic discharge (ESD) procedures to avoid damage to
Pull the handle to release the
tray.
tray.
Remove the fastening panels from the sides of the
tray.
TVS-x73e User Guide
Installation and Configuration
14
nd operating system installation and configuration steps.
This section provides information on installing drives, memory modules, and expansion cards.
inch solid state drives, and M.2 solid
Observe electrostatic discharge (ESD) procedures to avoid damage to
components.