QNAP TVS-73e Series - Installing QTS Using an HDMI Connection

• To
check for the latest available version, click
The wizard downloads the latest available version, and then the NAS restarts after the download
is complete. If a newer version is not available, the wizard automatically displays the
Installation Guide.
• To install the out-of-the-
box version, click
10. Click Start Smart Installation
11. Specify the following
information.
• NAS name
: Specify a name with 1 to 14 characters. The name supports letters (A to Z, a to z),
numbers (0 to 9), and hyphe
• Password
: Specify an administrator password with 1 to 64 characters. The password supports all
ASCII characters.
12. Click Next.
13.
Specify the time zone, date, and
Tip
QNAP recommends connecting to an NTP server to ensure that the NAS follows the
Coordinated Universal Time (UTC) standard.
14. Click Next.
15. Select
Obtain an IP address automatically
16. Click Next.
17.
Select the types of devices that you will use to access shared folders on the
18. Click Next.
19. Select Configure disks later.
Note
For details on configuring disks, see the Storage Manager section of the QTS User Guide.
20. Configure the disk settings.
a. Select a volume type.
b.
Select the disks that you want to use to create a RAID
c. Optional: Select a RAID
type.
Note
The
Smart Installation Guide
number of the selected disks.
d. Optional: Select
Encrypted Disk
21. Click Next.
22. Select No.
Installation and Configuration
check for the latest available version, click
Start.
The wizard downloads the latest available version, and then the NAS restarts after the download
is complete. If a newer version is not available, the wizard automatically displays the
box version, click
Skip.
Guide.
information.
: Specify a name with 1 to 14 characters. The name supports letters (A to Z, a to z),
numbers (0 to 9), and hyphe
ns (-), but cannot end with a hyphen.
: Specify an administrator password with 1 to 64 characters. The password supports all
Specify the time zone, date, and
time.
QNAP recommends connecting to an NTP server to ensure that the NAS follows the
Coordinated Universal Time (UTC) standard.
Obtain an IP address automatically
(DHCP).
Select the types of devices that you will use to access shared folders on the
NAS.
For details on configuring disks, see the Storage Manager section of the QTS User Guide.
Select the disks that you want to use to create a RAID
group.
type.
Smart Installation Guide automatically selects the optimal RAID type based on the
number of the selected disks.
Encrypted Disk
Volume and Bad Block Scan.
TVS-x73e User Guide
Installation and Configuration
35
The wizard downloads the latest available version, and then the NAS restarts after the download
is complete. If a newer version is not available, the wizard automatically displays the
Smart
: Specify a name with 1 to 14 characters. The name supports letters (A to Z, a to z),
: Specify an administrator password with 1 to 64 characters. The password supports all
QNAP recommends connecting to an NTP server to ensure that the NAS follows the
NAS.
For details on configuring disks, see the Storage Manager section of the QTS User Guide.
automatically selects the optimal RAID type based on the