4. Power on the SATA JBOD expansion units.
5. Power on the NAS.
6. Verify that the expansion units are recognized by the NAS.
a. Log on to QuTS hero as administrator.
b. Go to Main Menu > Storage & Snapshots > Overview > System .
c. Verify that the expansion units are listed.
Connecting USB Expansion Units
The TVS-hx74 supports connecting a maximum of two USB expansion units.
1. Connect the expansion unit to the NAS.
a. Connect the USB cable to the USB Type-B or USB Type-C port on the expansion unit.
b. Connect the USB cable to a USB 3.2 Gen 2 Type-A or USB Type-C port on the NAS.
Note
This image shows connecting the TVS-h874 to the TL-R1200-CP expansion enclosures.
TVS-hx74 User Guide
Installation and Conguration 40
To Next Page
Loading...
Need help?
General
