Attero Tech by QSC Axiom Product Family
User Manual
QSC, LLC 2020 614-00063
– USB1 – Device Installation
USB1 – Mounting
A typical installation will involve mounting the wall plate into a
pre mounted wall box or mounting bracket. Before installation,
make sure the wall box where the USB1 is to be installed is pre-
wired with a suitable cable back to an Axiom-enabled
expander/injector.
Prior to USB1 installation, ensure the power sourcing device
(Axiom expander/injector) is powered off.
Attach and unshielded CAT-5/6 cable from the Axiom-enabled
device to the Axiom port A of the USB1.
With the cable attached, carefully place the USB1 into the wall
box taking care to not trap the cabling. Once in place, secure
it with the screws provided. Once the unit is secured in the wall
box, fit the Decora plate and secure it with the screws
provided.
Now you may apply power to the Axiom-enabled
expander/injector, the unit will power up and the signal
presence LEDs should blink once quickly.
The USB1 comes in a single gang US Decora style form factor
and may be mounted in most US single old and new work back
boxes and mud-rings. Given the single gang size, the USB1
may be mounted in larger gang boxes with other single gang
form factor products to provide flexible AV system modularity
where needed.
*Note: CAD drawings can be downloaded from the QSC
website. Please contact QSC for any further product related
information that is not accessible on the website.
To Next Page
Loading...