QSC ATTEROTECH Axiom Series - USB1 Status LEDs; USB1 USB Audio Modes; USB1 Device Config & Workflow Overview

Attero Tech by QSC Axiom Product Family
User Manual
 QSC, LLC 2020 614-00063
– USB1 – Status LEDs
The USB1 is equipped with a single LED indicator above the USB
port. The following chart indicates the available LED status
information:
LED State
Status
Off
No power/boot
Blinking Green
Booting
Green
Normal Powered State
Blinking Yellow
Identify
Blinking Red
Muted
– USB1 – USB Audio Modes
The USB1 supports 16-bit/48 kHz audio with three configurable
sound card options with which the USB audio interface will declare
itself.
o 1x1 Speakerphone (no host AEC)
o 1x1 Speakerphone (host AEC)
o 2x0/1x0 Line in/Line out
USB audio will be routed through the following Axiom ports based
on each corresponding audio mode. Modes are set using unIFY
Control Panel.
Mode
Axiom Pair A
Axiom Pair B
1 x 1 Play/Record
USB Playback Mono
USB Record Mono
2 x 0 Play Only
USB Playback Left
USB Playback Right
1 x 0 Play Only
USB Playback Mono
N/A
– Device Config & Workflow Overview
The USB1 may be configured for single use, or daisy-chained with
one other Axiom device.
The default configuration is for single device use with Port B
disabled and Ch2 transmitting via Port A.
Figure 11 – Switch/Label Config Options