QSC PLD Series - Using the Preset Wizard; Step 1: Adjust Impedance and Power; Step 2: Select Output Channel for Speaker Assignment; Step 3: Select Speaker Type for Channel

6
To start the Wizard: HOME > PRESETS > PRESET WIZARD > ENTER
STEP 1 — Adjust Impedance and Power
OUTPUTS SPEAKERS SAVE
AB CD
Output:
8.0 - - - - - -
Imped:
25 - - - - - -
Power:
Remaining Power Available: 1875 W
Enter Load Profile (Impedance and Power)
To confirm, press
Adjust Impedance
Default = 8 Ω
Default = min. for amp
Adjust Impedance based on the total loudspeaker load connected to the channel.
ENTER
Adjust Power
— Figure 14 —
Modes:
A B = Separate Channels
A+B = Bridge Mode
AB = Parallel Mode
A B + C D
8.0
2475
A B C D
8.0
2500
8.0
625
A
8.0
625
B
8.0
625
C
8.0
625
D
8.0
1250
A+B
8.0
625
C
8.0
625
D
8.0
1250
A+B
8.0
1250
C+D
Possible Output Mode Combinations using the Preset Wizard
STEP 2 — Select Output Channel for Speaker Assignment
OUTPUTS SPEAKERS SAVE
Assign
AssignAssign
Output:
ADCB
Imped:
8.0 8.08.08.0
Spkr:
- - - - - - - -- - - -- - - -
Assign
Power:
625 625625625
Loudspeaker assignment is optional.
To Assign a loudspeaker, press
Optional: Scroll to desired Output channel
ENTER
STEP 3 — Select Speaker Type for Channel
OUTPUTS SPEAKERS SAVE
Output:
A
CONFIRM
2-Way LF
Speaker:
80 Hz
Band:
WL2102 BiLFNS
Filter:
Band and Filter
selections are based
on the Speaker.
Scroll to select Speaker type
To edit Speaker, press
ENTER
Scroll to edit Band then Filter
To exit edit mode and confirm, press
ENTER
STEP 4 — Save Wizard Preset
Edit preset number or press EXIT
User Preset Number:
21
SAVE
New Preset Name
Con f i g - A
OUTPUTS SPEAKERS SAVE
Scroll to the Save screen
To name and save the preset,
Complete steps 1 thru 3 under
“To Save a New User Preset”
To edit User Preset number, press
ENTER