QSC TouchMix-8 - FX Processors; FX Processors - Basic Chorus

49
TD-000472-00-B
FX Processors
FX Processors – Basic Chorus
The Chorus FX Varies the pitch of a signal at a steady rate to “thicken” a sound.
Refer to — Figure 46
1.
LFO Type Switch – Selects how the pitch will be varied. Sine will vary
the pitch smoothly. Saw will cause the pitch to change abruptly and then
ramp back.
2.
LFO Rate Knob – Determines the rate at which the pitch will be varied.
3.
LFO Depth Knob – Controls the amount of modulation applied to the
audio signal.
4. Lo Cut Knob – Attenuates, or “cuts” frequencies below this frequency
setting. Range is 20 Hz to 2 kHz.
5. Hi Cut Knob – Attenuates, or “cuts” frequencies above this frequency
setting. Range is 200 Hz to 20 kHz.
Home
FX Masters
Select FX
Channel
+
FX
Chorus
Eect
FX Masters
FX 1
Select ChorusSelect
Effect
— Figure 46 —
1
2 3 4
5
— Figure 47 —
.1 3.5
Less Depth More Depth
Depth
.35 Hz 5.0 Hz
Slower Faster
Rate
Sine
Saw
Type