QTech QSW-2800 series - Page 191

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
177
Configure trusted IP
Configure automatic recovery time
Display relative information of debug information and ARP scanning
1. Enable the ARP Scanning Prevention function.
Command
Explanation
Global configuration mode
anti-arpscan enable
no anti-arpscan enable
Enable or disable the ARP Scanning Prevention
function globally.
2. Configure the threshold of the port-based and IP-based ARP Scanning Prevention
Command
Explanation
Global configuration mode
anti-arpscan port-based threshold
<threshold-value>
no anti-arpscan port-based
threshold
Set the threshold of the port-based ARP Scanning
Prevention.
anti-arpscan ip-based threshold
<threshold-value>
no anti-arpscan ip-based threshold
Set the threshold of the IP-based ARP Scanning
Prevention.
3. Configure trusted ports
Command
Explanation
Port configuration mode
anti-arpscan trust <port | supertrust-port>
no anti-arpscan trust <port |
supertrust-port>
Set the trust attributes of the ports.
4. Configure trusted IP
Command
Explanation
Global configuration mode
anti-arpscan trust ip <ip-address>
[<netmask>]
no anti-arpscan trust ip <ip-address>
[<netmask>]
Set the trust attributes of IP.
5. Configure automatic recovery time
Command
Explanation