QTech QSW-2800 series - Page 286

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
272
[no]{deny|permit}{any-source-mac|{host-source-
mac<host_smac>}|{<smac><smac-mask>}} {any-
destination-mac|{host-destination-mac
<host_dmac>}|{<dmac><dmac-mask>}}udp
{{<source><source-wildcard>}|any-source| {host-
source<source-host-ip>}} [s-port {<port1> | range
<sPortMin> <sPortMax>}]
{{<destination><destination-wildcard>}|any-
destination| {host-destination <destination-host-ip>}}
[d-port {<port3> | range <dPortMin> <dPortMax>}]
[precedence <precedence>] [tos <tos>][time-
range<time-range-name>]
Creates an extended name-based
MAC-UDP access rule; the no
form command deletes this name-
based extended MAC-UDP access
rule.
[no]{deny|permit}{any-source-mac|{host-source-
mac<host_smac>}|{<smac><smac-mask>}} {any-
destination-mac|{host-destination-mac
<host_dmac>}|{<dmac><dmac-mask>}}
{eigrp|gre|igrp|ip|ipinip|ospf|{<protocol-num>}}
{{<source><source-wildcard>}|any-source| {host-
source<source-host-ip>}}
{{<destination><destination-wildcard>}|any-
destination| {host-destination<destination-host-ip>}}
[precedence<precedence>][tos<tos>][time-
range<time-range-name>]
Creates an extended name-based
access rule for the other IP
protocol; the no form command
deletes this name-based extended
access rule.
c. Exit MAC-IP Configuration Mode
Command
Explanation
Extended name-based MAC-IP access Mode
exit
Quit extended name-based MAC-IP access
mode.
(10) Configuring a numbered standard IPv6 access-list
Command
Explanation
Global Mode
ipv6 access-list <num> {deny | permit}
{{<sIPv6Addr> <sPrefixlen>} | any-source |
{host-source <sIpv6Addr>}}
no ipv6 access-list <num>
Creates a numbered standard IPv6 access-
list, if the access-list already exists, then a
rule will add to the current access-list; the “no
access-list <num>“ command deletes a
numbered standard IPv6 access-list.
(11) Configuring a standard IPv6 access-list based on nomenclature