+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
radius-server authentication host {
<IPaddress> | <IPv6address> } [[port
{<portNum>}] [key <string>] [primary]
[access-mode {dot1x|telnet}]
no radius-server authentication host
<IPaddress>
Specifies the IP address and listening port
number, cipher key, whether be primary
server or not and access mode for the
RADIUS server; the no command deletes the
RADIUS authentication server.
radius-server accounting host {<ipv4-
address> | <ipv6-address>} [port <port-
number>] [key <string>] [primary]
no radius-server accounting host {<ipv4-
address> | <ipv6-address>}
Specifies the IPv4/IPv6 address and the port
number, whether be primary server for
RADIUS accounting server; the no command
deletes the RADIUS accounting server.
4. Configure the parameter of the RADIUS service
radius-server dead-time <minutes>
no radius-server dead-time
To configure the interval that the RADIUS
becomes available after it is down. The no
form of this command will restore the default
configuration.
radius-server retransmit <retries>
no radius-server retransmit
To configure retry times for the RADIUS
packets. The no form of this command
restores the default configuration.
radius-server timeout <seconds>
no radius-server timeout
To configure the timeout value for the
RADIUS server. The no form of this command
will restore the default configuration.
radius-server accounting-interim-update
timeout <seconds>
no radius-server accounting-interim-
update timeout
To configure the update interval for
accounting. The no form of this command will
restore the default configuration.
5. Configure the IP address of the RADIUS NAS
radius nas-ipv4 <ip-address>
no radius nas-ipv4
To configure the source IP address for the
RADIUS packets for the switch.
radius nas-ipv6 <ipv6-address>
no radius nas-ipv6
To configure the source IPv6 address for the
RADIUS packets for the switch.
To Next Page
Loading...
Need help?
General
