Functions: Primary Controls
LED UI
The In Level knob and CV input control the incoming signal amplitude.
The knob is silent when the knob is fully to the left.
Audio is at full amplitude when the knob is at center position.
As the knob turns from center position to the right, tape saturation and compression are intro-
duced to the incoming signal!
In Level CV Input range: -5V to +5V
1. In Level
Stardust’s LED UI is more than just pretty lights. It also provides visual feedback for all
sorts of functions, controls, and indications. This includes but is not limited to loop position,
VU metering, loop saving and import/exporting, and more.
8
The Mix knob and CV input blend between the dry and wet signal. When the knob is fully CCW,
only the dry signal is present. When the knob is fully CW, only the wet signal is present.
The default Mix curve is Constant Power.
Mix CV Input range: -5V to +5V
Did You Know?
You can change Stardust’s mix curve using Narwhal? Learn about the different mix
curve options in the Configurator section of the manual, then head to Narwhal to try them out!
2. Mix
To Next Page