9
Manually configuring LAN communication settings
In some unique instances, the LAN settings may have to be programmed into
the IS series mailing machine in order to establish a valid connection via LAN.
To manually configure LAN settings on an IS series mailing machine for a new
install, the actions below are required. If not, the system will continue to auto-
matically start the installation wizard and forbid the configuration of the LAN
settings.
Remove the power from the system; remove the PSD (meter); plug the system
back in and wait until the system boots up.
1. When the system powers on with no PSD (meter), you will be requi-
red to clear a “boot with no PSD” message. Press “OK” to display the screen
below. Press the “Menu” button.
No stamp
No printing
Note: if there is no cartridge in the system, other messages may have to be
cleared by pressing OK.
2. Scroll down and select “13 Supervisor”.
10. Application
11. Preferences
12. Cartridge
13. Supervisor
Main Menu
To Next Page
Loading...
