EasyManuals Logo

Quadra-Fire 3100 Series Owner's Manual

Quadra-Fire 3100 Series
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
5 7033-362C 11/21
2000-645H 2
Warranty Period HHT Manufactured Appliances and Venting
Parts Labor Gas Pellet Wood Electric Venting Components Covered
6 years 3 years X Catalyst - Limitations Listed
7 years 3 years X X
Manifold Tubes HHT
Chimney and Termination
10 years 1 year X Burners, Logs and Refractory
Limited
Lifetime
3 years X X X
Firebox and Heat Exchanger, FlexBurn
®
System
(engine, inner cover, access cover and reback)
1 year None X X X X X All Replacement Parts beyond Warranty Period
OTHER RIGHTS
The HHT manufacturers warranty is in addition to other rights and remedies that you may have under Australian
law.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled
to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality
and the failure does not amount to a major failure.
WARRANTY CONDITIONS AND EXCLUSIONS:
The HHT manufacturers warranty only covers HHT appliances that are purchased through an HHT authorized dealer
or distributor. A list of HHT authorized dealers is available on the HHT branded websites.
This warranty is only valid while the HHT appliance remains at the site of original installation.
WARRANTY EXCLUSIONS:
This HHT manufacturers warranty does not cover the following:
Changes in surface nishes as a result of normal use. As a heating appliance, some changes in color of interior and
exterior surface nishes may occur. This is not a aw and is not covered under warranty.
Damage to printed, plated, or enamelled surfaces caused by ngerprints, accidents, misuse, scratches, melted items,
or other external sources and residues left on the plated surfaces from the use of abrasive cleaners or polishes.
Repair or replacement of parts that are subject to normal wear and tear during the warranty period. These parts in-
clude: paint, wood, pellet and coal gaskets, rebricks, grates, ame guides, light bulbs, batteries and the discoloration
of glass.
Expansion, contraction, or movement of certain parts causing noise. These conditions are normal and complaints
related to this noise are not covered by this warranty.
Damages resulting from: (1) failure to install, operate, or maintain the appliance in accordance with the installation
instructions, operating instructions, and listing agent identication label furnished with the appliance; (2) failure to in-
stall the appliance in accordance with local building codes; (3) shipping or improper handling; (4) improper operation,
abuse, misuse, continued operation with damaged, corroded or failed components, accident, or improperly/incorrectly
performed repairs; (5) environmental conditions, inadequate ventilation, negative pressure, or drafting caused by
tightly sealed constructions, insu󰀩cient make-up air supply, or handling devices such as exhaust fans or forced air fur-
naces or other such causes; (6) use of fuels other than those specied in the operating instructions; (7) installation or
use of components not supplied with the appliance or any other components not expressly authorized and approved
by HHT (8) modication of the appliance not expressly authorized and approved by HHT in writing; and/or (9) interrup-
tions or uctuations of electrical power supply to the appliance.
2000-645G (5-20) Page 2 of 3
OTHER RIGHTS
The HHT manufacturers warranty is in addition to other rights and remedies that you may have under Australian
law.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled
to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality
and the failure does not amount to a major failure.
WARRANTY CONDITIONS AND EXCLUSIONS:
The HHT manufacturers warranty only covers HHT appliances that are purchased through an HHT authorized dealer or
distributor. A list of HHT authorized dealers is available on the HHT branded websites.
This warranty is only valid while the HHT appliance remains at the site of original installation.
WARRANTY EXCLUSIONS:
This HHT manufacturers warranty does not cover the following:
Changes in surface nishes as a result of normal use. As a heating appliance, some changes in color of interior and
exterior surface nishes may occur. This is not a aw and is not covered under warranty.
Damage to printed, plated, or enamelled surfaces caused by ngerprints, accidents, misuse, scratches, melted items, or
other external sources and residues left on the plated surfaces from the use of abrasive cleaners or polishes.
Repair or replacement of parts that are subject to normal wear and tear during the warranty period. These parts include:
paint, wood, pellet and coal gaskets, rebricks, grates, ame guides, light bulbs, batteries and the discoloration of glass.
Expansion, contraction, or movement of certain parts causing noise. These conditions are normal and complaints related
to this noise are not covered by this warranty.
Damages resulting from: (1) failure to install, operate, or maintain the appliance in accordance with the installation
instructions, operating instructions, and listing agent identifi cation label furnished with the appliance; (2) failure to install
the appliance in accordance with local building codes; (3) shipping or improper handling; (4) improper operation, abuse,
misuse, continued operation with damaged, corroded or failed components, accident, or improperly/incorrectly performed
repairs; (5) environmental conditions, inadequate ventilation, negative pressure, or drafting caused by tightly sealed
constructions, insuffi cient make-up air supply, or handling devices such as exhaust fans or forced air furnaces or other
such causes; (6) use of fuels other than those specifi ed in the operating instructions; (7) installation or use of components
not supplied with the appliance or any other components not expressly authorized and approved by HHT (8) modifi cation
of the appliance not expressly authorized and approved by HHT in writing; and/or (9) interruptions or uctuations of
electrical power supply to the appliance.
All manuals and user guides at all-guides.com

Other manuals for Quadra-Fire 3100 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Quadra-Fire 3100 Series and is the answer not in the manual?

Quadra-Fire 3100 Series Specifications

General IconGeneral
EPA CertifiedYes
Flue Size6 inches
Efficiency78%
Firebox Size2.0 cu ft
Log Length18 inches
Depth26.5 inches
Maximum Burn Time10 hours

Related product manuals